Nissan Altima 2007-2012 Service Manual: Normal operating condition
Description
XENON HEADLAMP
• The brightness and color of the light may vary slightly immediately after turning the headlamp ON. This condition will remain until the xenon bulb becomes stable. This is normal.
• Illumination time lag may occur between right and left. This is normal.
AUTO LIGHT SYSTEM
The auto light system may not turn the headlamp ON/OFF immediately after passing a dark area or a bright area (short tunnel, sky bridge, shadowed area etc.). This is normal.
Exterior lighting system symptoms
Symptom Table
CAUTION:
Perform the self-diagnosis with CONSULT-III before the symptom diagnosis.
Perform the trouble diagnosis
if any DTC is detected.
...
Both side headlamps do not switch
to high beam
Description
The headlamps (both sides) do not switch to high beam when the lighting
switch is in the HI or PASS setting.
Diagnosis Procedure
1.COMBINATION SWITCH INSPECTION
Check the combinati ...
Other materials:
Main line between dlc and abs circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector side
and harness side).
- Harness co ...
Microphone
Removal and Installation
REMOVAL
1. Remove the room/map lamp assembly. Refer to INL-121, "Removal and
Installation".
2. Detach the microphone connector (A).
3. Remove the map lamp covers (1), then remove the map lamp
assembly cover (2).
4. Release the microphone tabs (A), th ...
Front drive shaft
Removal and Installation (Left Side)
1. Drive shaft
2. Cotter pin
REMOVAL
1. Remove wheel and tire. Refer to WT-66, "Adjustment".
2. Remove wheel sensor from steering knuckle. Refer to BRC-63, "Removal and
Installation" (ABS), BRC-
134, "Removal and Installation& ...
