Nissan Altima 2007-2012 Service Manual: Occupant classification system

System Diagram

Occupant Classification System (OCS)

The occupant classification system (OCS) identifies if a child or child seat is present in the front passenger seat. The OCS receives inputs from the occupant classification sensor mat (located inside the passenger seat cushion assembly). Depending on classification of the passenger, the OCS control unit sends a signal to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit uses this signal and the seat belt buckle switch RH signal to determine deployment or non deployment of the front passenger air bag module in the event of a collision. Depending on the signals received, the air bag diagnosis sensor unit can disable the front passenger air bag module completely.

NOTE: In case of customer concern, CONSULT-III can be used to confirm the front passenger air bag status (readiness).

Front Passenger Air Bag Status Conditions

NOTE: Passenger does not meet Occupant Classification System specifications for passenger air bag activation.

1. Seat cushion foam

2. OCS control unit

3. OCS sensor mat

4. OCS sensor mat cell (internal)

    SRS air bag system
    SRS Configuration The air bag deploys if the air bag diagnosis sensor unit is activated while the ignition switch is in the ON or START position. The collision modes for which supplemental r ...

    Passenger seat belt warning system
    System Diagram System Description The seat belt warning lamp (1) will remind the driver if the driver or front passenger seat belt should be buckled. The system works in conjunction with the oc ...

    Other materials:

    Precaution
    Supplemental Restraint System (SRS) "AIR B AG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and fron ...

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - ECM - Harnes ...

    Inspection and adjustment
    ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT  Service After Replacing TCM and Transaxle Assembly Perform the applicable service in the following sheet when replacing TCM or transaxle assembly. CAUTION: • Do not start the engine until the service is completed. • “TCM-POWER S ...