Nissan Altima (L32) 2007-2012 Service Manual: Oil filter
Removal and Installation
REMOVAL
1. Remove the engine undercover.
2. Remove the oil filter using Tool (A) as shown.
WARNING: • Be careful not to get burned, the engine and engine oil may be hot.
CAUTION: • When removing, prepare a shop cloth to absorb any oil leakage or spillage.
• Do not allow engine oil to adhere to the drive belts.
• Completely wipe off any oil that adheres to the engine and the vehicle.
• The oil filter has a built in pressure relief valve. Use a genuine NISSAN oil filter or equivalent
INSTALLATION
1. Remove foreign materials adhering to the oil filter installation surface.
2. Apply clean engine oil to the oil seal contact surface of the new oil filter.
3. Screw the oil filter manually until it touches the installation surface, then tighten it by 2/3 turn. Or tighten to specification below.
4. Check the oil level and add engine oil as necessary. Refer to LU-23.
5. After warming up the engine, check for any engine oil leaks.
Engine oil
Changing Engine Oil WARNING: • Be careful not to burn yourself, as the engine oil may be hot. • Prolonged and repeated contact with used engine oil may cause skin cancer; try to avoid dire ...Spark plug
Removal and Installation 1. Ignition coil 2. Spark plug 3. Rocker cover RH 4. Rocker cover LH REMOVAL 1. Remove the ignition coil. Refer to EM-145, "Removal and Installation LH" a ...Other materials:
Additional service when replacing control unit
Description
When replacing ECM, this procedure must be performed.
Special Repair Requirement
1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS IGNITION
KEY IDS
Refer to SEC-15, "ECM RE-COMMUNICATING FUNCTION : Special Repair Requirement"
(Coupe) or SEC-
214, &qu ...
Seat belts
The seat belts can be cleaned by wiping them
with a sponge dampened in a mild soap solution.
Allow the belts to dry completely in the shade
before using them. See “Seat belt maintenance”
in the “Safety – Seats, seat belts and supplemental
restraint system” section of this manual.
W ...
B2604 PNP switch
Description
BCM confirms the shift position with the following 4 signals.
• CVT selector lever
• P/N position switch
• P position signal from IPDM E/R (CAN)
• P position signal from TCM (CAN)
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2604 is displayed with DTC U1000, first ...