Nissan Altima (L32) 2007-2012 Service Manual: Oil filter
Removal and Installation
REMOVAL
1. Remove the engine undercover.
2. Remove the oil filter using Tool (A) as shown.
Tool number : KV10115801 (J-38956)
WARNING: • Be careful not to get burned, the engine and engine oil may be hot.
CAUTION: • When removing, prepare a shop cloth to absorb any oil leakage or spillage.
• Do not allow engine oil to adhere to the drive belts.
• Completely wipe off any oil that adheres to the engine and the vehicle.
• The oil filter has a built in pressure relief valve. Use a genuine NISSAN oil filter or equivalent
INSTALLATION
1. Remove foreign materials adhering to the oil filter installation surface.
2. Apply clean engine oil to the oil seal contact surface of the new oil filter.
3. Screw the oil filter manually until it touches the installation surface, then tighten it by 2/3 turn. Or tighten to specification below.
4. Check the oil level and add engine oil as necessary. Refer to LU-23.
5. After warming up the engine, check for any engine oil leaks.
Engine oil
Inspection OIL LEVEL NOTE: • Before starting the engine, check the oil level. If the engine is already started, stop it and allow 10 minutes before checking. • Check that the oil level is w ...Other materials:
Rear seat head restraints/headrests
WARNING
● Head restraints/headrests supplement
the other vehicle safety systems. They
may provide additional protection
against injury in certain rear end collisions.
Adjust the head
restraints/headrests properly, as specified
in this section. Check the adjustment
after someone else ...
General maintenance
During the normal day-to-day operation of the
vehicle, general maintenance should be performed
regularly as prescribed in this section. If
you detect any unusual sounds, vibrations or
smells, be sure to check for the cause or have a
NISSAN dealer do it promptly. In addition, you
should notify ...
B2190, P1610 nats antenna amp
Description
Performs ID verification through BCM and keyfob when push-button ignition
switch is pressed.
Prohibits the release of steering lock or start of engine when an unregistered
ID of keyfob is used.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMA ...