Nissan Altima 2007-2012 Service Manual: On-vehicle maintenance
FRONT WHEEL HUB
Inspection
• Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of wheel bearing.
Axial end play : 0.05 mm (0.002 in) or less
• Rotate wheel hub and make sure that is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly
FRONT DRIVE SHAFT
Inspection
• Check drive shaft mounting point and joint for looseness and other damage.
• Check boot for cracks and other damage. CAUTION: Replace entire drive shaft assembly when noise or vibration occur from drive shaft.
Preparation
Special Service Tool
The actual shapes of Kent-Moore tools may differ from those of special
service tools illustrated here.
Commercial Service Tool
...
Other materials:
Front power window switch
Description
Main power window and door lock/unlock switch, power window and door
lock/unlock switch RH and BCM
transmit and receive the signal by power window serial link.
The signal mentioned below is transmitted from BCM to main power window and door
lock/unlock switch and
power window a ...
P0643 sensor power supply
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following proced ...
Headlamp (xenon type)
Wiring Diagram - Coupe
Wiring Diagram - Sedan
...