Nissan Altima 2007-2012 Service Manual: On-vehicle maintenance

WHEEL HUB

On-vehicle Service

Check axle and suspension parts for excessive play, wear or damage.

• Shake each rear wheel to check for excessive play.

Rear Wheel Bearing

• Check axial end play.

Axial end play : 0.1 mm (0.004 in) or less

• Check that wheel hub bearings operate smoothly.

• Replace wheel bearing assembly if there is axial end play or wheel bearing does not turn smoothly. Refer to FAX-8, "Removal and Installation".

    Preparation
    Commercial Service Tool ...

    On-vehicle repair
    WHEEL HUB Removal and Installation 1. Knuckle 2. Baffle plate 3. Wheel hub assembly 4. Brake rotor 5. Wheel nut 6. Anchor block 7. ABS sensor 8. Parking brake cable A. Refer to PB-6, " ...

    Other materials:

    Steering wheel
    Removal and Installation REMOVAL NOTE: When reconnecting spiral cable, fix cable with a tape so that fixing case and rotating part keep aligned. This will omit neutral position alignment procedure during spiral cable installation. 1. Set vehicle to the straight-ahead position. 2. Remove ...

    Rear window defogger system
    System Diagram System Description Operation Description • Turn rear window defogger switch ON when the ignition switch is turned ON. Then front air control (rear window defogger switch) transmits rear window defogger switch signal to BCM. • BCM turns rear window defogger relay ON whe ...

    B2553 ignition relay
    Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. • Ignition relay-1 (inside IPDM E/R) • Ignition relay-2 (inside fuse block) • Blower fan motor relay BCM checks any ignition relay ON request for consistency wit ...