Nissan Altima 2007-2012 Service Manual: On-vehicle maintenance
M/T OIL
Draining
1. Start engine and let it run to warm up transaxle oil.
2. Stop engine and remove the drain plug to drain the oil.
3. Install the drain plug with a new gasket to the transaxle case. Tighten the drain plug to the specified torque. Refer to TM-28, "Exploded View".
CAUTION: Do not reuse gasket.
Refilling
1. Remove the filler plug (1) and fill transaxle with new oil.
Oil grade : Refer to MA-12, "Fluids and Lubricants".
2. After refilling oil, measure oil level to check if it is within the specification using suitable gauge (A) as shown.
CAUTION: • Do not start engine while checking oil level.
• Insert the suitable gauge straight and against the wall of the filler plug hole, then measure the gauge from the top of the filler plug hole to the oil level as shown.
Oil level “L” : Refer to TM-82, "General Specifications".
3. Install the filler plug with a new O-ring to the clutch housing.
CAUTION: Do not reuse O-ring. 4. Tighten filler plug bolt to the specified torque. Refer to TM-28, "Exploded View".
Inspection
LEAKAGE
• Make sure that oil is not leaking from transaxle or around it.
LEVEL
1. Remove the filler plug (1).
2. Measure oil level to check if it is within the specification using a suitable gauge (A) as shown.
CAUTION: • Do not start engine while checking oil level.
• Insert the suitable gauge straight and against the wall of the filler plug hole, then measure the gauge from the top of the filler plug hole to the oil level as shown.
Oil level “L” : Refer to TM-82, "General Specifications".
3. Install the filler plug with a new O-ring to the clutch housing.
CAUTION: Do not reuse O-ring. 4. Tighten the filler plug bolt to the specified torque. Refer to TM-28, "Exploded View".
Preparation
Special Service Tools The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here. Commercial Service Tools ...Other materials:
Power window main switch
Description
Main power window and door lock/unlock switch, power window and door
lock/unlock switch RH and BCM
transmit and receive the signal by power window serial link.
The signal mentioned below is transmitted from BCM to main power window and door
lock/unlock switch and
power window ...
AV control unit (sedan)
Reference Value
VALUES ON THE DIAGNOSIS TOOL
CONSULT-III data monitor item
TERMINAL LAYOUT
PHYSICAL VALUES
Wiring Diagram
DTC Index
...
Precautions on child restraints
WARNING
Failure to follow the warnings and instructions
for proper use and installation
of child restraints could result in
serious injury or death of a child or
other passengers in a sudden stop or
collision:
– The child restraint must be used and
installed properly. Always follow all ...