Nissan Altima (L32) 2007-2012 Service Manual ≻ Transaxle & transmission cvt: RE0F09B ≻ On-vehicle maintenance ≻ On-vehicle repair

Nissan Altima (L32) 2007-2012 Service Manual: On-vehicle repair

TRANSMISSION CONTROL MODULE

Exploded View

1. TCM

2. Bracket

3. Battery

Removal and Installation

REMOVAL

1. Disconnect the battery negative terminal. Refer to PG-139, "Removal and Installation".

2. Remove the fresh air intake tube (upper) EM-25, "Removal and Installation".

3. Disconnect the TCM harness connector.

4. Remove the TCM (1) from the bracket (2).

• Battery (3)

INSTALLATION

Installation is in the reverse order of removal.

CVT Position

Inspection and Adjustment INSPECTION 1. Place selector lever in “P” position, and turn ignition switch ON (engine stop). 2. Make sure that selector lever can be shifted to other than “P� ...

Control device

Exploded View 1. Control lever knob 2. Lock pin 3. Knob cover 4. Control device selector plate 5. Control device assembly Removal and Installation REMOVAL 1. Remove the center console assem ...

Other materials:

Bluetooth connections screen
"" (back) key Bluetooth tab Connections screen "Add New" key "" (settings) key "" (info) key "" (Bluetooth Audio connection) key "" (Bluetooth Hands-Free Phone System connection) key Access the Connections screen to change settings and view Bluetooth information. To access the Connec ...

BSW system operation
For vehicles with the 7 inch (18 cm) display Side BSW/RCTA Indicator Light BSW indicator The BSW system operates above approximately 20 mph (32 km/h). If the radar sensors detect a vehicle in the detection zone, the side BSW/RCTA indicator light (1) illuminates. If the turn signal is then acti ...

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused by objects such ...