Nissan Altima 2007-2012 Service Manual: On-vehicle repair
- Transmission control module
- Control device
- Control cable
- Differential side oil seal
- Air breather hose
- Park/neutral position (PNP) switch
- Primary speed sensor
- Secondary speed sensor
- Oil pump fitting bolt
- Control valve
CVT position
Inspection and Adjustment
INSPECTION
1. Place selector lever in “P” position, and turn ignition switch ON (engine
stop).
2. Make sure that selector lever can be shifted to other than “P ...
Transmission control module
Exploded View
1. TCM
2. Bracket
3. Battery
Removal and Installation
REMOVAL
1. Disconnect the battery negative terminal.
2. Remove the fresh air intake tube (upper).
3. Disconnect the ...
Other materials:
B260C steering lock unit
Description
The electronic steering column lock performs the check by itself according to
the steering status.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Turn ignition switch OFF.
3. Press door switch. ...
Clutch pedal
Exploded View
1. Clutch pedal assembly
2. Clutch interlock switch
3. ASCD clutch switch
4. Lock nut
Removal and Installation
REMOVAL
1. Disconnect master cylinder rod end from clutch pedal lever.
2. Disconnect the ASCD clutch switch and clutch interlock switch
harness connectors.
3. ...
Hood
1 Pull the hood lock release handle located
below the driver’s side instrument panel; the
hood springs up slightly.
2 Push the lever at the front of the hood to the
side as illustrated with your fingertips and
raise the hood.
3 Remove the support rod from the clamp.
4 Insert the support r ...
