Nissan Altima 2007-2012 Service Manual: On-vehicle repair

POWER WINDOW MAIN SWITCH

Removal and Installation

REMOVAL

1. Remove the power window main switch finisher (2). Refer to INT-12, "Removal and Installation".

2. Power window main switch (1) is removed from power window main switch finisher (2) using a suitable tool (A).

CAUTION: Do not fold the pawl of power window main switch finisher.

NOTE: The same procedure is also performed for front power window and door lock/unlock switch RH, and rear power window switch (LH & RH).

INSTALLATION

Installation is in the reverse order of removal.

    On-vehicle maintenance
    PRE-INSPECTION FOR DIAGNOSTIC Basic Inspection BASIC INSPECTION 1.INSPECTION START 1. Check the service history. 2. Check the following parts. • Fuse/circuit breaker blown. • Poor con ...

    Other materials:

    P1217 engine over temperature
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC P1217 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. • If DTC P1217 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to EC-866, "DTC Logic". If the cooling ...

    BCM (Body control module)
    Reference Value VALUES ON THE DIAGNOSIS TOOL Terminal Layout Physical Values 1: Sedan only 2: With LH front window anti-pinch 3: With LH and RH front window anti-pinch Wiring Diagram-Coupe Wiring Diagram-Sedan ...

    Fuel gauge
    System Diagram System Description The fuel gauge indicates the approximate fuel level in the fuel tank. The fuel gauge is regulated by the unified meter control unit and a variable resistor signal supplied by the fuel level sensor unit.  Component Parts Location 1. Combination ...