Nissan Altima (L32) 2007-2012 Service Manual: On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-34, "Removal and Installation".
2. Power window main switch (1) is removed from power window
main switch finisher (2) using a suitable tool (A).
CAUTION:
Do not fold the pawl of power window main switch finisher.
NOTE:
The same procedure is also performed for front power window and
door lock/unlock switch RH, and rear power window switch (LH &
RH).
INSTALLATION
Installation is in the reverse order of removal.
PRE-INSPECTION FOR DIAGNOSTIC
Basic Inspection
1.INSPECTION START
1. Check the service history.
2. Check the following parts.
• Fuse/circuit breaker blown.
• Poor connection, open or s ...
Other materials: Installing the spare tire
WARNING
For AWD vehicles - the TEMPORARY USE
ONLY spare tire must be installed to the
rear wheels only. If a front tire is punctured,
install the original rear tire onto
the front wheel, then install the TEMPORARY
USE ONLY spare tire on the rear.
Failure to do so could cause overheating
to the AWD ...
System temporarily unavailable
For vehicles with the 7 inch (18 cm) display
Condition A
When the radar sensor picks up interference
from another radar source, making it
impossible to detect a vehicle ahead, the
I-FCW system is automatically turned off.
The AEB with Pedestrian Detection system
warning light (yellow) will illumin ...
Active noise cancellation/Active sound
enhancement (if so equipped)
Active noise cancellation
Front Microphone
This system uses microphones 1 located
inside the vehicle to detect engine booming
noise. The system then automatically generates
a noise cancelling sound through the
speakers and woofer (if so equipped) to reduce
engine booming noise.
NOTE:
To operate the ...
On-vehicle maintenance
Power window control system lh&rh front anti-pinch-coupe