Nissan Altima 2007-2012 Service Manual: On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to INT-12, "Removal and Installation".
2. Power window main switch (1) is removed from power window main switch finisher (2) using a suitable tool (A).
CAUTION: Do not fold the pawl of power window main switch finisher. NOTE: The same procedure is also performed for front power window and door lock/unlock switch RH, and rear power window switch (LH & RH).
INSTALLATION
Installation is in the reverse order of removal.
On-vehicle maintenance
PRE-INSPECTION FOR DIAGNOSTIC Basic Inspection 1.INSPECTION START 1. Check the service history. 2. Check the following parts. • Fuse/circuit breaker blown. • Poor connection, open or s ...Other materials:
Air breather hose
Exploded View
1. Clip
2. Air cleaner case
3. Transaxle assembly
4. Clip
5. Air breather hose
A. Set paint mark and clip at front side
1. Air cleaner case
2. Transaxle assembly
3. Clip
4. Air breather hose
5. Clip
A. Set paint mark and clip at front side
Removal and Installation
...
On board diagnostic (OBD) System
Diagnosis Description
DESCRIPTION
The CVT system has two self-diagnostic systems.
The first is the emission-related on board diagnostic system (OBD-II) performed
by the TCM in combination
with the ECM. The malfunction is indicated by the MIL (malfunction indicator
lamp) and is stored as a ...
Anti-pinch system does not operate normally (driver side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the mal ...