Nissan Altima 2007-2012 Service Manual: On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to INT-34, "Removal and Installation".
2. Power window main switch (1) is removed from power window main switch finisher (2) using a suitable tool (A).
CAUTION: Do not fold the pawl of power window main switch finisher. NOTE: The same procedure is also performed for front power window and door lock/unlock switch RH, and rear power window switch (LH & RH).
INSTALLATION
Installation is in the reverse order of removal.
On-vehicle maintenance
PRE-INSPECTION FOR DIAGNOSTIC Basic Inspection 1.INSPECTION START 1. Check the service history. 2. Check the following parts. • Fuse/circuit breaker blown. • Poor connection, open or s ...Roof
...Other materials:
Maintenance precautions
When performing any inspection or maintenance
work on your vehicle, always take care to prevent
serious accidental injury to yourself or damage to
the vehicle. The following are general precautions
which should be closely observed.
WARNING
● Park the vehicle on a level surface, apply
th ...
Shift fork and fork rod
Exploded View
Refer to TM-28, "Exploded View".
Disassembly
1. Remove return spring to striking rod assembly.
Assembly
1. Temporarily install return spring to striking rod assembly.
CAUTION:
Be careful with the orientation of return spring.
2. Attach one end of the return s ...
B210C starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay
operation when in N or P position and
the steering is locked or unlocked. It is installed in parallel with the starter
relay.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210C is displayed with DTC U10 ...