Nissan Altima 2007-2012 Service Manual: On-vehicle repair

EVAP CANISTER

Exploded View

Removal and Installation

REMOVAL

1. Lift up the vehicle.

2. Remove EVAP canister fixing bolt.

3. Remove EVAP canister.

NOTE: The EVAP canister vent control valve and EVAP canister system pressure sensor can be removed without removing the EVAP canister.

INSTALLATION

Install in the reverse order of removal.

NOTE: Tighten EVAP canister fixing bolt to the specified torque.

DISASSEMBLY

1. Turn EVAP canister vent control valve counterclockwise.

A : Lock

B : Unlock

2. Remove the EVAP canister vent control valve.

ASSEMBLY

Assemble in the reverse order of disassembly.

CAUTION: Always replace O-ring with a new one.

Inspection

Check EVAP canister as follows: 1. Block port (B).

2. Blow air into port (A) and check that it flows freely out of port (C).

3. Release blocked port (B).

4. Apply vacuum pressure to port (B) and check that vacuum pressure exists at the ports (A) and (C).

5. Block port (A) and (B).

6. Apply pressure to port (C) and check that there is no leakage.

    Evap leak check
    Inspection CAUTION: • Do not use compressed air or a high pressure pump. • Do not exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system. NOTE: • Do not start engine. • ...

    Service data and specifications (SDS)
    Idle Speed *: Under the following conditions • A/C switch: OFF • Electric load: OFF (Lights, heater fan & rear window defogger) • Steering wheel: Kept in straight-ahead position Igni ...

    Other materials:

    Common ITEM
     Diagnosis Description BCM CONSULT-III FUNCTION CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for all sub system s ...

    Communication signal circuit (sedan)
    SATELLITE RADIO TUNER Description Communication signals are exchanged between the audio unit and satellite radio tuner using the communication circuits.  Diagnosis Procedure 1.CHECK HARNESS - 1 1. Turn ignition switch OFF. 2. Disconnect satellite radio tuner (factory installed) conn ...

    P0746 pressure control solenoid a performance (line pressure solenoid valve)
    Description The pressure control solenoid valve A (line pressure solenoid valve) regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a ...