Nissan Altima 2007-2012 Service Manual: On-vehicle repair

STARTER MOTOR

Removal and Installation

M/T MODELS

Removal

1. Disconnect the negative battery terminal.

2. Disconnect the starter motor harness connectors.

3. Remove the two starter motor bolts, using power tools.

4. Remove the starter motor.

Installation

Installation is in the reverse order of removal.

Removal and Installation

CVT Models

REMOVAL

1. Remove the battery and battery tray bracket. For Sedan Refer to PG-139, "Removal and Installation" For Coupe Refer to PG-68, "Removal and Installation" 2. Remove the air cleaner assembly ducts.

3. Disconnect the following: • ECM

• TCM

4. Disconnect the starter motor harness connectors.

5. Remove the two starter motor bolts, using power tools.

6. Remove the starter motor.

INSTALLATION

Installation is in the reverse order of removal.

Disassembly and Assembly

DISASSEMBLY

1. Set the starter motor assembly (2) onto a suitable tool using a soft cloth as shown.

2. Remove the terminal "M" nut (A) from terminal "M" (1).

3. Disconnect terminal "M" connector (1).

4. Remove the two magnet switch assembly screws (A) and remove the magnet switch assembly (1).

CAUTION: Magnet switch assembly (1) may pop out from starter motor assembly (2) while loosening magnet switch assembly screws.

ASSEMBLY

1. Install magnet switch assembly (3) onto starter motor assembly (1).

• Pull rod (5) of magnet switch assembly (3) should be engaged with shift lever (4) as shown. CAUTION: • Do not damage the sliding surface (2) of magnet switch assembly (3).

• Do not leave any dirt on the sliding surface (2) of the magnet switch assembly (3).

• Confirm the terminal location.

2. Tighten the two magnet switch assembly screws (A) to specification.

• Magnetic switch assembly (1) • Starter motor assembly (2)

3. Connect the terminal "M" connector and tighten terminal "M" nut (A) to specification.

• Starter motor assembly (2)

CAUTION: The connector for terminal "M" (1) may rotate easily while tightening terminal "M" nut (A). Hold the connector in place while tightening terminal "M" nut (A).

    Preparation
    Special Service Tool Commercial Service Tool ...

    Service data and specifications (SDS)
    STARTER MOTOR Starter ...

    Other materials:

    Noise
    Component Function Check SYMPTOM: Noise INSPECTION FLOW *1 HAC-5, "Operational Check" *2 EM-16, "Checking Drive Belts" (QR25DE) or EM-121, "Checking Drive Belts" (VQ35DE) *3 HAC-87, "Performance Chart" *4 HA-45, "Removal and Installation for E ...

    Bluetooth® Hands-Free Phone System with Navigation System (if so equipped)
    WARNING ● Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle operation. ● If you are unable to devote full attention to vehicle operation while talkin ...

    DLC branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side) ...