Nissan Altima 2007-2012 Service Manual: On-vehicle repair
STARTER MOTOR
Removal and Installation
M/T Models
REMOVAL
1. Disconnect the negative battery terminal.
2. Disconnect the starter motor harness connectors.
3. Remove the two starter motor bolts, using power tools.
4. Remove the starter motor.
INSTALLATION
1. Installation is in the reverse order of removal.
Removal and Installation
CVT Models
REMOVAL
1. Disconnect the negative and positive battery terminal.
2. Remove the air cleaner assembly and air ducts.
3. Disconnect the following: • ECM
• TCM
4. Remove the battery tray. For Sedan Refer PG-139, "Removal and Installation". For Coupe Refer to PG- 68, "Removal and Installation" 5. Disconnect the starter motor harness connectors.
6. Remove the two starter motor bolts, using power tools.
7. Remove the starter motor.
INSTALLATION
Installation is in the reverse order of removal.
Preparation
Special Service Tool
Commercial Service Tool
...
Service data and specifications
(SDS)
STARTER MOTOR
Starter
...
Other materials:
Encoder
DRIVER SIDE
Description
Detects condition of the power window motor LH operation and transmits to
main power window and door
lock/unlock switch as pulse signal.
Component Function Check
1. CHECK ENCODER OPERATION
Does door glass LH perform AUTO open/close operation normally with main power ...
P0703 stop lamp switch
Description
BCM detects ON/OFF state of the stop lamp switch and transmits the data to
the TCM via CAN communication
by converting the data to a signal.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION P ...
P0441 Evap control system
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0441 is displayed with other DTC such as P2122, P2123, P2127, P2128 or
P2138, first perform
trouble diagnosis for other DTC.
In this evaporative emission (EVAP) control system, purge flow occurs during
non-closed throttle conditions.
Purge vo ...
