Nissan Altima 2007-2012 Service Manual: P0603 ECM Power supply

Description

Battery voltage is supplied to the ECM even when the ignition switch is turned OFF for the ECM memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the idle air volume learning value memory, etc.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON and wait at least 1 second.

2. Start engine and let it idle for 1 second.

3. Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.

4. Repeat steps 2 and 3 for four times.

5. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Go to EC-862, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK ECM POWER SUPPLY

1. Turn ignition switch OFF.

2. Disconnect ECM harness connector.

3. Check the voltage between ECM harness connector and ground.

Is the inspection result normal? YES >> GO TO 3.

NO >> GO TO 2.

2.DETECT MALFUNCTIONING PART

Check the following.

• 15A fuse (No. 42) • IPDM E/R harness connector F10

• Harness for open or short between ECM and battery

>> Repair or replace harness or connectors.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace harness or connectors.

4.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Select “SELF-DIAG RESULTS” mode with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC CONFIRMATION PROCEDURE.

See EC-862, "DTC Logic".

1. Turn ignition switch ON.

2. Select Service $04 with GST.

3. Perform DTC CONFIRMATION PROCEDURE.

See EC-862, "DTC Logic".

Is the 1st trip DTC P0603 displayed again? YES >> GO TO 5.

NO >> INSPECTION END

5.REPLACE ECM

1. Replace ECM.

2. Go to EC-563, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

>> INSPECTION END

    P0550 PSP Sensor
    Description Power steering pressure (PSP) sensor is installed to the power steering high-pressure tube and detects a power steering load. This sensor is a potentiometer which transforms the pow ...

    P0605 ECM
    Description The ECM consists of a microcomputer and connectors for signal input and output and for power supply. The ECM controls the engine. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION P ...

    Other materials:

    Differential side oil seal
    Exploded View 1. Transaxle assembly 2. Differential side oil seal Removal and Installation REMOVAL 1. Remove drive shaft assembly. Refer to FAX-11, "Removal and Installation (Left Side)" and FAX-12, "Removal and Installation (Right Side)". 2. Remove the differential ...

    Automatic speed control device (ASCD)
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *: This signal is sent to the ECM through CAN communication line BASIC ASCD SYSTEM Refer to Owner's Manual for ASCD operating instructions. Automatic Speed Control Device (ASCD) allows a driver to keep vehicle at predetermin ...

    Combination meter
    Reference Value TERMINAL LAYOUT PHYSICAL VALUES Wiring Diagram - Coupe Wiring Diagram - Sedan Fail Safe The combination meter performs a fail-safe operation for the functions listed below when communication is lost ...