Nissan Altima 2007-2012 Service Manual: P0615 start signal

Description

• TCM controls starter relay in IPDM E/R.

• TCM switches starter relay ON at “P” or “N” position and allows to crank engine.

• Then it prohibits cranking other than at “P” or “N” position.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

CAUTION: Always drive vehicle at a safe speed.

Always drive vehicle at a safe speed.

NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF.

Then wait at least 10 seconds before performing the next test.

1.CHECK DTC DETECTION

1. Turn ignition switch ON.

2. Perform “SELF-DIAG RESULTS” mode for “TRANSMISSION”.

Is “P0615 STARTER RELAY/CIRC” detected? YES >> Go to TM-124, "Diagnosis Procedure".

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Diagnosis Procedure

1.CHECK STARTER RELAY SIGNAL

1. Turn ignition switch OFF.

2. Disconnect TCM harness connector and IPDM E/R harness connector F10.

3. Turn ignition switch ON.

4. Check voltage between IPDM E/R harness connector F10 terminal 72 and ground.

Is the inspection result normal? YES >> Check starter relay and starter control relay. Refer to PCS-14, "Diagnosis Description".

NO >> GO TO 2.

2.CHECK HARNESS BETWEEN TCM AND IPDM E/R (PART 1)

1. Turn ignition switch OFF.

2. Check continuity between TCM harness connector F16 (A) terminal 20 and IPDM E/R harness connector F10 (B) terminal 72.

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace damaged parts.

3.CHECK HARNESS BETWEEN TCM AND IPDM E/R 2 (PART 2)

Check continuity between TCM harness connector F16 terminal 20 and ground.

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace damaged parts.

4.DETECT MALFUNCTIONING ITEMS

Check TCM connector pin terminals for damage or loose connection with harness connector.

Is the inspection result normal? YES >> Replace TCM. Refer to TM-254, "Exploded View".

NO >> Repair or replace damaged parts.

    U1000 CAn comm circuit
    Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

    P0703 stop lamp switch
    Description BCM detects ON/OFF state of the stop lamp switch and transmits the data to the TCM via CAN communication by converting the data to a signal. DTC Logic DTC DETECTION LOGIC DTC CON ...

    Other materials:

    Bose speaker AMP
    Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER SUPPLY CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect BOSE speaker amp connector. 3. Chec ...

    Cooling fan control
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: The ECM determines the start signal status by the signals of engine speed and battery voltage. *2: This signal is sent to ECM via the CAN communication line. SYSTEM DESCRIPTION The ECM controls the cooling fan correspondin ...

    Ambient sensor signal circuit
    Description Transmits the ambient sensor signal to the combination meter. Component Function Check 1.COMBINATION METER INPUT SIGNAL 1. Select “METER/M&A” on CONSULT-III. 2. Using “OUTSIDE TEMP” on “DATA MONITOR”, compare the value of DATA MONITOR with temperature display ...