Nissan Altima 2007-2012 Service Manual: P1726 electric throttle control system

Description

Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM with CAN communication.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ignition switch OFF.

Then wait at least 10 seconds before performing the next test.

1.CHECK DTC DETECTION

1. Start engine and let it idle for 5 seconds.

2. Perform “SELF-DIAG RESULTS” mode for “TRANSMISSION”.

Is “P1726 ELEC TH CONTROL” detected? YES >> Go to TM-357, "Diagnosis Procedure".

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Diagnosis Procedure

1.CHECK DTC WITH ECM

1. Turn ignition switch ON.

2. Select “SELF-DIAG RESULTS” mode for “ENGINE”.

Is the inspection result normal? YES >> GO TO 2.

NO >> Check DTC Detected Item. Refer to EC-527, "DTC Index" (for California), EC-1015, "DTC Index" (except for California).

2.CHECK DTC WITH TCM

Perform “SELF-DIAG RESULTS” mode for “TRANSMISSION”.

Is “P1726 ELEC TH CONTROL” detected? YES >> Replace TCM. Refer to TM-430, "Exploded View".

NO >> GO TO 3.

3.DETECT MALFUNCTIONING ITEMS

Check TCM connector pin terminals for damage or loose connection with harness connector.

Is the inspection result normal? YES >> Replace TCM. Refer to TM-430, "Exploded View".

NO >> Repair or replace damaged parts.

    P1723 cvt speed sensor function
    Description The vehicle speed sensor CVT [output speed sensor (secondary speed sensor)] detects the revolution of parking gear and generates a pulse signal. The pulse signal is sent to the TCM, ...

    P1740 lock-up select solenoid valve
    Description • Lock-up select solenoid valve controls lock-up clutch pressure or forward clutch pressure (reverse brake pressure). • When controlling lock-up clutch, the valve is turned OFF ...

    Other materials:

    Stop lamp
    Bulb Replacement Removal 1. Remove rear combination lamp. Refer to EXL-257, "Removal and Installation". 2. Turn bulb socket counterclockwise to unlock and remove from combination lamp assembly. 3. Turn bulb counterclockwise to remove from bulb socket. Installation Installati ...

    Electrical load signal
    Description The electrical load signal (Headlamp switch signal, rear window defogger switch signal, etc.) is transferred through the CAN communication line. Component Function Check 1.CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION 1. Turn ignition switch ON. 2. Connect CONSULT-III and select ...

    P0725 engine speed signal
    Description The engine speed signal is transmitted from ECM to TCM by CAN communication line. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn ig ...