Nissan Altima 2007-2012 Service Manual: Parking brake control

PEDAL TYPE

Exploded View

1. Control device assembly

2. Parking brake switch

3. Pedal pad

4. Adjusting nut

5. Lock plate

6. Front cable

7. Rear cable RH

8. Rear cable LH

9. Equalizer

10. Spring

11. Pin

 Removal and Installation

REMOVAL

1. Remove rear wheel and tires. Refer to WT-66, "Adjustment".

2. Remove instrument lower cover and lower knee protector. Refer to IP-11, "Exploded View".

3. Disconnect parking brake switch connector.

4. Remove adjusting nut and discard, then loosen front cable.

CAUTION: Do not reuse adjusting nut. 5. Remove control device assembly nuts and remove control device assembly.

6. Remove center console. Refer to IP-11, "Exploded View".

7. Separate rear cables from front cable, remove front cable.

8. Remove heat insulator of the exhaust center tube.

9. Remove parking brake shoe, and remove rear cables from toggle lever. Refer to IP-11, "Exploded View".

10. Remove rear cable bolts and nuts, then remove rear cables.

INSTALLATION

Installation is in the reverse order of removal.

• Adjust the parking brake with new adjusting nut. Refer to PB-3, "PEDAL TYPE : Adjustment".

CAUTION: Do not reuse adjusting nut.

LEVER TYPE

 Exploded View

1. Control device assembly

2. Adjusting nut

3. Front cable

4. Equalizer

5. Rear cable (RH)

6. Rear cable (LH)

7. Pin

Removal and Installation

REMOVAL

1. Remove rear wheel and tires. Refer to WT-66, "Adjustment".

2. Remove center console. Refer to IP-18, "Disassembly and Assembly".

3. Disconnect parking brake switch connector.

4. Remove adjusting nut and discard. Loosen cable, then disconnect rear cables from equalizer.

CAUTION: Do not reuse adjusting nut. 5. Remove control device assembly nuts and remove control device assembly.

6. Remove heat insulator for the exhaust center tube.

7. Remove parking brake shoes, and disconnect rear cable from toggle lever. Refer to PB-9, "Removal and Installation".

8. Remove rear cable bolts and nuts, then remove rear cables.

INSTALLATION

Installation is in the reverse order of removal.

• Adjust parking brake. Refer to PB-4, "LEVER TYPE : Adjustment".

CAUTION: Do not reuse adjusting nut.

    Parking brake shoe
    Exploded View 1. Return spring 2. Adjuster 3. Brake shoe 4. Anti-rattle pin 5. Retainer 6. Anti-rattle spring 7. Toggle lever PBC (Poly Butyl Cuprysil) grease or silicone-based grease Re ...

    Other materials:

    Ambient sensor
    Description COMPONENT DESCRIPTION Ambient Sensor The ambient sensor (1) is attached on the front bumper reinforcement. It detects ambient temperature and converts it into a resistance value which is then input into the front air control. AMBIENT TEMPERATURE INPUT PROCESS The automatic am ...

    Door key cylinder switch
    Description Main power window and door lock/unlock switch detects condition of the door key cylinder and transmits to BCM as the LOCK or UNLOCK signals. Component Function Check 1. CHECK DOOR KEY CYLINDER SWITCH INPUT SIGNAL Check (“KEY CYL LK-SW”, “KEY CYL UN-SW”) in “DATA MONITOR ...

    On-vehicle repair
    EVAP CANISTER Exploded View Removal and Installation REMOVAL 1. Lift up the vehicle. 2. Remove EVAP canister fixing bolt. 3. Remove EVAP canister. NOTE: The EVAP canister vent control valve and EVAP canister system pressure sensor can be removed without removing the EVAP canister ...