Nissan Altima 2007-2012 Service Manual: Passenger side

 Description

Detects condition of the power window motor RH operation and transmits to power window and door lock/ unlock switch RH as pulse signal.

Component Function Check

1. CHECK ENCODER OPERATION

Does door glass RH perform AUTO open/close operation normally when operating power window and door lock/unlock switch RH? Is the inspection result normal? YES >> Encoder operation is OK.

NO >> Refer to PWC-209, "PASSENGER SIDE : Diagnosis Procedure".

Diagnosis Procedure

1. CHECK ENCODER SIGNAL

1. Turn ignition switch ON.

2. Check signal between power window and door lock/unlock switch RH connector and ground with oscilloscope.

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 2

2. CHECK POWER WINDOW MOTOR RH POWER SUPPLY

1. Turn ignition switch ON.

2. Check voltage between power window motor RH connector and ground.

Is the measurement value within the specification? YES >> GO TO 4

NO >> GO TO 3

3. CHECK HARNESS CONTINUITY 1

1. Turn ignition switch OFF.

2. Disconnect power window and door lock/unlock switch RH and power window motor RH.

3. Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).

4. Check continuity between power window and door lock/unlock switch RH connector (A) and ground.

Is the inspection result normal? YES >> Replace power window and door lock/unlock switch RH. Refer to PWC-291, "Removal and Installation".

After that, refer to PWC-201, "PASSENGER SIDE : Special Repair Requirement".

NO >> Repair or replace harness.

4. CHECK GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect power window motor RH.

3. Check continuity between power window motor RH connector and ground.

Is the inspection result normal? YES >> GO TO 6

NO >> GO TO 5

5. CHECK HARNESS CONTINUITY 2

1. Disconnect power window and door lock/unlock switch RH.

2. Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).

Is the inspection result normal? YES >> Replace power window and door lock/unlock switch RH.

Refer to PWC-291, "Removal and Installation". After that, refer to PWC-201, "PASSENGER SIDE : Special Repair Requirement".

NO >> Repair or replace harness.

6. CHECK HARNESS CONTINUITY 3

1. Disconnect power window and door lock/unlock switch RH.

2. Check continuity between power window and door lock/unlock switch RH connector (A) and power window motor RH connector (B).

3. Check continuity between power window and door lock/unlock switch RH connector (A) and ground.

Is the inspection result normal? YES >> Replace power window motor RH. Refer to GW-19, "Removal and Installation". After that, refer to PWC-205, "PASSENGER SIDE : Special Repair Requirement".

NO >> Repair or replace harness.

    Driver side
     Description Detects condition of the power window motor LH operation and transmits to main power window and door lock/unlock switch as pulse signal. Component Function Check 1. CHECK ENCO ...

    Door switch
    Description Detects door open/close condition and transmits the signal to BCM. Component Function Check 1. CHECK DOOR SWITCH INPUT SIGNAL Check (“DOOR SW-DR” and “DOOR SW-AS”) in “DATA ...

    Other materials:

    iPod®* player operation with Navigation System (if so equipped)
    Connecting iPod® WARNING Do not connect/disconnect or operate the USB device while driving. Doing so can be a distraction. If distracted you could lose control of your vehicle and cause an accident or serious injury. CAUTION ● Do not force the USB device into the USB port. Insertin ...

    B2553 ignition relay
    Description BCM turns ON the following relays to ignition power supply to each ECU when the ignition switch is turned ON. • Ignition relay-1 (inside IPDM E/R) • Ignition relay-2 (inside fuse block) • Blower fan motor relay BCM checks any ignition relay ON request for consistency wit ...

    Rear rh side power window alone does not operate
    Diagnosis Procedure 1. CHECK REAR POWER WINDOW SWITCH RH Check rear power winodw switch RH. Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the malfunctioning parts. 2. ...