Nissan Altima 2007-2012 Service Manual: Positive crankcase ventilation

Description

This system returns blow-by gas to the intake manifold.

The positive crankcase ventilation (PCV) valve is provided to conduct crankcase blow-by gas to the intake manifold.

During partial throttle operation of the engine, the intake manifold sucks the blow-by gas via the PCV valve.

Normally, the capacity of the valve is sufficient to handle any blow-by and a small amount of ventilating air.

The ventilating air is drawn from the air inlet tubes into the crankcase. In this process the air passes via the hose connecting air inlet tubes to rocker cover.

Under full-throttle condition, the manifold vacuum is insufficient to draw the blow-by flow via the valve.

The flow goes via the hose connection in the reverse direction.

On vehicles with an excessively high blow-by, the valve does not meet the requirement. This is because some of the flow will go via the hose connection to the air inlet tubes under all conditions.

Component Inspection

1.CHECK PCV VALVE

With engine running at idle, remove PCV valve from rocker cover. A properly working valve makes a hissing noise as air passes via the it.

A strong vacuum should be felt immediately when a finger is placed over valve inlet.

Is the inspection result normal? YES >> INSPECTION END

NO >> Replace PCV valve.

    On board refueling vapor recovery (ORVR)
    Description From the beginning of refueling, the air and vapor inside the fuel tank go via the refueling EVAP vapor cut valve and EVAP/ORVR line to the EVAP canister. The vapor is absorbed by th ...

    Refrigerant pressure sensor
    Description The refrigerant pressure sensor is installed at the condenser of the air conditioner system. The sensor uses an electrostatic volume pressure transducer to convert refrigerant pressure ...

    Other materials:

    Microphone
    Diagnosis Procedure 1.CHECK POWER SUPPLY CIRCUIT (MICROPHONE SIDE) Check voltage between microphone harness connector and ground. Is proper voltage present? YES >> GO TO 4 NO >> GO TO 2 2.CHECK POWER SUPPLY CIRCUIT (CONTINUITY) 1. Turn ignition switch OFF. 2. Disconnect mic ...

    Condenser
    Removal and Installation - Coupe REMOVAL 1. Remove the rear seat cushion and the rear seatback. Refer to SE-25, "Removal and Installation". 2. Remove the rear kicking plate, rear wheel well garnish and the rear pillar finisher. Refer to INT-19, "Removal and Installation&q ...

    Cooling fan control
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: The ECM determines the start signal status by the signals of engine speed and battery voltage. *2: This signal is sent to ECM through CAN communication line. SYSTEM DESCRIPTION ECM controls cooling fan speed correspondin ...