Nissan Altima 2007-2012 Service Manual: POWER STEERING OIL PUMP
Inspection
RELIEF OIL PRESSURE
CAUTION: Make sure that belt tension is normal before starting the following procedure.
1. Connect the Tool between oil pump discharge connector and high-pressure hose. Bleed air from the hydraulic circuit while opening valve fully. Refer to ST-8, "Inspection".
2. Start engine. Run engine until oil temperature reaches 50° to 80°C (122° to 176°F).
CAUTION: • Leave the valve of the hydraulic pressure gauge [SST] fully open while starting and running engine. If engine is started with the valve closed, the hydraulic pressure in oil pump goes up to the relief pressure along with unusual increase of oil temperature.
• Be sure to keep hose clear of belts and other parts when engine is started. 3. Fully close the Tool valve with engine at idle and measure the relief oil pressure.
CAUTION: Never keep valve closed for 10 seconds or longer.
4. Open the valve slowly after measuring. Replace oil pump is the relief oil pressure is outside the standard.
5. After inspection, disconnect the Tool from hydraulic circuit, then add fluid and bleed air. Refer to ST-8, "Inspection".
Steering wheel
Inspection
INSTALLATION CONDITION
• Check installation conditions of steering gear assembly, front suspension
assembly, axle and steering column
assembly.
• Check if movement exists when s ...
Other materials:
ECU diagnosis
AIR CONDITIONER CONTROL
Reference Value
VALUES ON THE DIAGNOSIS TOOL
TERMINAL LAYOUT
PHYSICAL VALUES
Wiring Diagram - Air Conditioner Control (Auto) -
Coupe
Wiring Diagram - Air Conditioner Control (Auto) -
Sedan
...
Installing top tether strap
First, secure the child restraint with the LATCH
lower anchors (rear outboard seat positions only)
or the seat belt, as applicable.
1. Flip up the anchor cover 1 from the anchor
point which is located directly behind the
child seat.
2. Position the top tether strap over the top of
the hea ...
During a call
While a call is active, press the
button to
access additional options. Speak one of the following
commands:
● “Send” – Speak this command followed by
the digits to enter digits during the phone
call.
● “Mute On” or “Mute Off” – Speak the command
to mute or unmu ...