Nissan Altima 2007-2012 Service Manual: Power supply and ground circuit

Description

• EPS system functions by ignition power supply.

Diagnosis Procedure

1.CHECK POWER SUPPLY

1. Turn the ignition switch OFF.

2. Disconnect power steering control unit harness connector.

3. Check voltage between power steering control unit harness connector M59 terminal 3 and ground.

4. Turn the ignition switch ON.

CAUTION: Never start the engine.

5. Check voltage between power steering control unit harness connector M59 terminal 3 and ground.

Is the inspection result normal? YES >> GO TO 2.

NO >> Check the following. If any items are damaged, repair or replace damaged parts.

• 10A fuses (#3) open - Harness for short or open between ignition switch and power steering control unit harness connector No. 3 terminal.

- Ignition switch.

2.CHECK GROUND CIRCUIT

1. Turn the ignition switch OFF.

2. Check continuity between power steering control unit harness connector M59 terminal 6 and ground.

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair open circuit or short to power in harness or connectors.

3.CHECK TERMINALS AND HARNESS CONNECTORS

Check power steering control unit pin terminals for damage or loose connection with harness connector.

Is the inspection result normal? YES >> Inspection End

NO >> Repair or replace damaged parts.

    Power steering solenoid valve
    Description • Power steering solenoid valve controls the power steering oil pressure in the gear housing assembly. Diagnosis Procedure 1.CHECK POWER STEERING SOLENOID VALVE SIGNAL 1. Start e ...

    Other materials:

    P0139, P0159 HO2S2
    Description The heated oxygen sensor 2, after three way catalyst (manifold), monitors the oxygen level in the exhaust gas on each bank. Even if switching characteristics of the air fuel ratio (A/F) sensor 1 are shifted, the air-fuel ratio is controlled to stoichiometric, by the signal from th ...

    Component diagnosis
    Wiring Diagram - Coupe Wiring Diagram - Sedan ...

    Control device
    Exploded View 1. Control lever knob 2. Lock pin 3. Knob cover 4. Control device selector plate 5. Control device assembly Removal and Installation REMOVAL 1. Remove the center console assembly. Refer to IP-12, "Removal and Installation". 2. Disconnect the control cable from ...