Nissan Altima (L32) 2007-2012 Service Manual ≻ Body control system bcm ≻ Component diagnosis ≻ Power supply and ground circuit

Nissan Altima (L32) 2007-2012 Service Manual: Power supply and ground circuit

Diagnosis Procedure

1. CHECK FUSE AND FUSIBLE LINK

Check if the following BCM fuse or fusible link are blown.

Is the fuse or fusible link blown? YES >> Replace the blown fuse or fusible link after repairing the affected circuit.

NO >> GO TO 2

2. CHECK POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM.

3. Check voltage between BCM harness connector and ground.

Is the measurement normal? YES >> GO TO 3

NO >> Repair or replace harness.

3. CHECK GROUND CIRCUIT

Check continuity between BCM harness connector and ground.

Does continuity exist? YES >> Inspection End.

NO >> Repair or replace harness.

Special Repair Requirement

1. REQUIRED WORK WHEN REPLACING BCM

Initialize control unit. Refer to BCS-6, "CONFIGURATION (BCM) : Special Repair Requirement".

>> Work End.

B2562 low voltage

DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1. DTC CONFIRMATION 1. Erase DTC. 2. Turn ignition switch OFF. 3. Perform the "SELF-DIAG RESULTS" of CONSULT-III, after t ...

Combination switch input circuit

Diagnosis Procedure 1. CHECK INPUT 1 - 5 SYSTEM CIRCUIT FOR OPEN 1. Turn the ignition switch OFF. 2. Disconnect the BCM and combination switch. 3. Check continuity between BCM harness connect ...

Other materials:

How to use the vehicle information display
The vehicle information display can be changed using the , , and OK buttons located on the steering wheel. - Use these buttons to navigate the vehicle information display. OK - Change or select an item in the vehicle information display. - Returns to the previous menu. The OK, and butto ...

Programming trouble-diagnosis
If the HomeLink does not quickly learn the hand-held transmitter information: Replace the hand-held transmitter batteries with new batteries. Position the hand-held transmitter with its battery area facing away from the HomeLink surface. Press and hold both the HomeLink and hand-held transmi ...

NISSAN Intelligent Key battery discharge
If the battery of the NISSAN Intelligent Key is discharged or environmental conditions interfere with the Intelligent Key operation, start the engine according to the following procedure: 1. Place the shift lever in the P (Park) position. 2. Firmly apply the foot brake. 3. Touch the ignition switc ...