Nissan Altima (L32) 2007-2012 Service Manual: Power supply routing circuit
Wiring Diagram — Battery Power Supply —
Wiring Diagram — Accessory Power Supply —
Wiring Diagram — Ignition Power Supply —
Fuse
• If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
• Use fuse of specified rating. Never use fuse of more than specified rating.
• Do not partially install fuse; always insert it into fuse holder properly.
• Remove fuse for “ELECTRICAL PARTS (BAT)” if vehicle is not used for a long period of time.
Fusible Link
A melted fusible link can be detected either by visual inspection or by feeling with finger tip. If its condition is questionable, use circuit tester or test lamp.
1 : Fusible link
CAUTION: • If fusible link should melt, it is possible that critical circuit (power supply or large current carrying circuit) is shorted. In such a case, carefully check and eliminate cause of malfunction.
• Never wrap outside of fusible link with vinyl tape. Important: Never let fusible link touch any other wiring harness, vinyl or rubber parts.
Ground
Ground Distribution MAIN HARNESS ENGINE ROOM HARNESS FRONT END MODULE HARNESS ENGINE CONTROL HARNESS BODY HARNESS BODY NO. 2 HARNESS HARNESS Harness Layout HOW TO READ HARNE ...Other materials:
Towing recommended by NISSAN
NISSAN recommends that your vehicle be towed
with the driving (front) wheels off the ground or
place the vehicle on a flat bed truck as illustrated.
CAUTION
● Never tow Continuously Variable Transmission
(CVT) models with the front
wheels on the ground or four wheels on
the ground ( ...
Exhaust manifold and three way
catalyst
Removal and Installation
1. Exhaust manifold heat shield (RH)
2. Air fuel ratio (A/F) sensor 1 (bank 1)
3. Exhaust manifold (RH)
4. Gaskets
5. Heated oxygen sensor 2 (bank 1)
6. Three way catalyst (manifold) (bank
1)
7. Three way catalyst (manifold) (bank
2)
8. Heated oxygen sensor 2 (ba ...
B2190, P1610 nats antenna amp
Description
Performs ID verification through BCM and keyfob when push-button ignition
switch is pressed.
Prohibits the release of steering lock or start of engine when an unregistered
ID of keyfob is used.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMA ...