Nissan Altima 2007-2012 Service Manual: Power window control system lh&rh front anti-pinch-sedan
- Basic inspection
- Function diagnosis
- Component diagnosis
- Power supply and ground circuit
- Power window motor
- Encoder
- Door key cylinder switch
- Power window serial link
- Power window lock switch
- ECU diagnosis
- Precaution
- Symptom diagnosis
- None of the power windows can be operated using any switch
- Driver side power window alone does not operate
- Front passenger side power window alone does not operate
- Rear lh side power window alone does not operate
- Rear rh side power window alone does not operate
- Anti-pinch system does not operate normally (driver side)
- Anti-pinch system does not operate normally (passenger side)
- Auto operation does not operate but manual operates normally (driver side)
- Auto operation does not operate but manual operates normally (passenger side)
- Power window retained power operation does not operate properly
- Does not operate by key cylinder switch
- Keyless power window down does not operate
- Power window lock switch does not function
- On-vehicle maintenance
- On-vehicle repair
On-vehicle repair
POWER WINDOW MAIN SWITCH
Removal and Installation
REMOVAL
1. Remove the power window main switch finisher (2). Refer to
INT-12, "Removal and Installation".
2. Power window main sw ...
Basic inspection
...
Other materials:
P0444, p0445 evap canister purge
volume control solenoid valve
Description
The EVAP canister purge volume control solenoid valve uses a ON/
OFF duty to control the flow rate of fuel vapor from the EVAP canister.
The EVAP canister purge volume control solenoid valve is
moved by ON/OFF pulses from the ECM. The longer the ON pulse,
the greater the amount of ...
None of the power windows can be
operated using any switch
Diagnosis Procedure
1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit.
Refer to BCS-42, "Diagnosis Procedure".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK MAIN POWER W ...
P0143 HO2S3
Description
The heated oxygen sensor 3, after HC adsorption catalyst (Under
floor), monitors the oxygen level in the exhaust gas on each bank.
This sensor is made of ceramic zirconia. The zirconia generates voltage
from approximately 1V in richer conditions to 0V in leaner conditions.
Unde ...