Nissan Altima 2007-2012 Service Manual: Power window lock switch does not function
Diagnosis Procedure
1.REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Replace main power window and door lock/unlock switch.
Refer to PWC-91, "Removal and Installation". After that, PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspection result normal? YES >> Inspection End.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Power window retained power operation does not operate properly
Diagnosis Procedure 1. CHECK DOOR SWITCH Check door switch. Refer to PWC-32, "Component Function Check". Is the inspection result normal? YES >> Inspection End. NO >> ...On-vehicle maintenance
PRE-INSPECTION FOR DIAGNOSTIC Basic Inspection BASIC INSPECTION 1.INSPECTION START 1. Check the service history. 2. Check the following parts. • Fuse/circuit breaker blown. • Poor con ...Other materials:
B210E starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210E is displaye ...
Floor mats
WARNING
To avoid potential pedal interference that
may result in a collision or injury:
● NEVER place a floor mat on top of another
floor mat in the driver front
position.
● Use only genuine NISSAN floor mats
specifically designed for use in your vehicle
model. See your NISSAN de ...
Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connectors on CAN communication system.
4. Check terminals and connectors for damage, bend and loose con ...