Nissan Altima 2007-2012 Service Manual: Power window lock switch does not function
Diagnosis Procedure
1.REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Replace main power window and door lock/unlock switch.
Refer to PWC-186, "Removal and Installation". After that, PWC-108, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".
Is the inspection result normal? YES >> Inspection end.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Power window retained power operation
does not operate properly
Diagnosis Procedure
1. CHECK FRONT DOOR SWITCH
Check front door switch.
Refer to PWC-124, "Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
...
On-vehicle maintenance
PRE-INSPECTION FOR DIAGNOSTIC
Basic Inspection
1.INSPECTION START
1. Check the service history.
2. Check the following parts.
• Fuse/circuit breaker blown.
• Poor connection, open or s ...
Other materials:
BCM branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the BCM for damage, bend and loose
connection (unit side and
connector side).
Is the inspec ...
Speedometer
System Diagram
System Description
The ABS actuator and electric unit (control unit) provides a vehicle speed
signal to the combination meter via
CAN communication lines.
Component Parts Location
1. Combination meter M24
2. IPDM E/R E17, E18, E201, F10
3. ECM E10
4. TCM F16
5. BCM ...
P0171, P0174 Fuel injection system function
DTC Logic
DTC DETECTION LOGIC
With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture
ratio can be brought closely to the
theoretical mixture ratio based on the mixture ratio feedback signal from A/F
sensor 1. The ECM calculates
the necessary compensation to correct the off ...