Nissan Altima 2007-2012 Service Manual: Power window lock switch does not function

Diagnosis Procedure

1. REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH

Replace main power window and door lock/unlock switch.

Refer to PWC-411, "Removal and Installation". After that, PWC-307, "POWER WINDOW MAIN SWITCH : Special Repair Requirement".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Keyless power window down does not operate
    Diagnosis Procedure 1. CHECK INTELLIGENT KEY FUNCTION Check Intelligent Key function. Refer to DLK-340, "Component Function Check". Is the inspection result normal? YES >> Ch ...

    On-vehicle maintenance
    PRE-INSPECTION FOR DIAGNOSTIC Basic Inspection 1.INSPECTION START 1. Check the service history. 2. Check the following parts. • Fuse/circuit breaker blown. • Poor connection, open or s ...

    Other materials:

    Camera on signal circuit (sedan)
    Description When the selector lever is placed in the R position, the rear view camera control unit sends a camera ON signal to the rear view camera. Diagnosis Procedure 1.CHECK CAMERA ON SIGNAL CIRCUIT CONTINUITY 1. Turn ignition switch OFF. 2. Disconnect rear view camera control unit con ...

    P0452 Evap control system pressure sensor
    Description The EVAP control system pressure sensor detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously condu ...

    Diagnosis sensor unit
    Removal and Installation REMOVAL 1. Diagnosis sensor unit harness connector 2. Diagnosis sensor unit shield 3. Diagnosis sensor unit A. Diagnosis sensor unit bolts CAUTION: • Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes ...