Nissan Altima Owners Manual: Precautions on cruise control
1. CANCEL switch
2. ACCEL/RES switch
3. COAST/SET switch
4. ON/OFF switch
● If the cruise control system malfunctions, it cancels automatically. The SET indicator light in the instrument panel then blinks to warn the driver.
● If the SET indicator light blinks, turn the cruise control switch off and have the system checked by a NISSAN dealer.
● The SET indicator light may blink when the cruise control switch is turned ON while pushing the ACCEL/RES, COAST/SET, or CANCEL switch. To properly set the cruise control system, use the following procedures.
WARNING
Do not use the cruise control when driving under the following conditions:
● When it is not possible to keep the vehicle at a set speed.
● In heavy traffic or in traffic that varies in speed.
● On winding or hilly roads.
● On slippery roads (rain, snow, ice, etc.).
● In very windy areas.
Doing so could cause a loss of vehicle control and result in an accident.
Cruise control operations
The cruise control allows driving at a speed between
25 - 89 MPH (40 - 144 km/h) without
keeping your foot on the accelerator pedal.
To turn on the cruise control, push the
ON·OFF switch on. Th ...
Other materials:
Tweeter (sedan)
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker
amp. amplifies the audio
signals before sending them to the front tweeters using the audio signal
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connector B122 and suspe ...
AV Branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the AV control unit for damage, bend
and loose connection (unit
side and connector side).
I ...
Park/neutral position (PNP) switch
Exploded View
1. Washer
2. Manual lever
3. PNP switch
4. CVT assembly
Removal and Installation
Refer to the figure for removal and installation.
NOTE:
• Align PNP switch position when installing.
• After installation of PNP switch, check the continuity of PNP switch.
• Afte ...