Nissan Altima (L32) 2007-2012 Service Manual: Primary speed sensor
Exploded View
1. CVT assembly
2. O-ring
3. Primary speed sensor
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Do not reuse O-ring.
• Apply CVT fluid to O-ring.
• After installation is complete, check for CVT fluid leakage and CVT fluid
level. Refer to TM-416,
"Inspection".
Exploded View
1. Washer
2. Manual lever
3. PNP switch
4. CVT assembly
Removal and Installation
Refer to the figure for removal and installation.
NOTE:
• Align PNP switch position when ...
Exploded View
1. CVT assembly
2. Shims
3. O-ring
4. Secondary Speed Sensor
Removal and Installation
Refer to the figure for removal and installation.
CAUTION:
• Do not reuse O-ring.
...
Other materials: Tachometer
5 inch (13 cm) Type A (if so equipped)
The tachometer indicates engine speed in
revolutions per minute (rpm).
Do not rev the engine into the red zone 1.
7 inch (18 cm) Type B (if so equipped)
CAUTION
When engine speed approaches the
red zone, shift to a higher gear or reduce
engine speed. Operati ...
System maintenance
The two radar sensors 1 for the BSW and
RCTA systems are located near the rear
bumper. Always keep the area near the radar
sensors clean.
The radar sensors may be blocked by temporary
ambient conditions such as splashing
water, mist or fog.
The blocked condition may also be caused
by objects such ...
Rapid air pressure loss
Rapid air pressure loss or a "blow-out" can
occur if the tire is punctured or is damaged
due to hitting a curb or pothole. Rapid air
pressure loss can also be caused by driving
on under-inflated tires.
Rapid air pressure loss can affect the handling
and stability of the vehicle, especially
at highw ...