Nissan Altima Owners Manual: Programming trouble-diagnosis
If the HomeLink® does not quickly learn the hand-held transmitter information: ● replace the hand-held transmitter batteries with new batteries.
● position the hand-held transmitter with its battery area facing away from the HomeLink® surface.
● press and hold both the HomeLink® and hand-held transmitter buttons without interruption.
● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink® surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink® is not programmed within that time, try holding the transmitter in another position – keeping the indicator light in view at all times.
If you have any questions or are having difficulty programming your HomeLink® buttons, refer to the HomeLink® web site at: www.homelink.com or call 1-800-355-3515.
Operating the HomeLink® universal transceiver
The HomeLink® Universal Transceiver, after it is programmed, can be used to activate the programmed device. To operate, simply press and release the appropriate programmed HomeLink® Universal Tr ...Clearing the programmed information
The following procedure clears the programmed information from both buttons. Individual buttons cannot be cleared. However, individual buttons can be reprogrammed. See “Reprogramming a single Ho ...Other materials:
Headlamp (xenon type)
Wiring Diagram - Coupe
Wiring Diagram - Sedan
...
Rear tweeter (coupe)
Description
The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker
amp. amplifies the audio
signals before sending them to the rear tweeters using the audio signal
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect BOSE speaker amp. connectors B121, B122 and
...
P0715 input speed sensor (pri speed
sensor)
Description
The input speed sensor (primary speed sensor) detects the primary pulley
revolution speed and sends a signal
to the TCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION PROCEDURE” has be ...