Nissan Altima 2007-2012 Service Manual: Push button ignition switch
Removal and Installation
REMOVAL
1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation".
2. Release the pawls (A) and remove the push-button ignition switch (1) from cluster lid A.
INSTALLATION
Installation is in the reverse order of removal.
Key slot
Removal and Installation
REMOVAL
1. Remove the instrument lower panel LH. Refer to IP-12, "Removal and
Installation".
2. Disconnect key slot connector.
3. Remove the key slot scre ...
Other materials:
Horn
Description
Horn (high/low) is located inside of front bumper and operates when theft
warning system is in alarm phase.
Component Function Check
1.CHECK FUNCTION
1. Select HORN in “ACTIVE TEST” mode with CONSULT-III.
2. Check the horn (high/low) operation.
Is the operation normal?
...
Diagnosis system (BCM)
COMMON ITEM
Diagnosis Description
BCM CONSULT-III FUNCTION
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub s ...
Intelligent key system/engine start function
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
SYSTEM DESCRIPTION
• The engine start function of Intelligent Key system is a system that makes
it possible to start and stop the
engine without removing the key. It verifies the electronic ID using two-way
communications w ...