Nissan Altima 2007-2012 Service Manual: Push button ignition switch
Removal and Installation
REMOVAL
1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation".
2. Release the pawls (A) and remove the push-button ignition switch (1) from cluster lid A.
INSTALLATION
Installation is in the reverse order of removal.
Key slot
Removal and Installation
REMOVAL
1. Remove the instrument lower panel LH. Refer to IP-12, "Removal and
Installation".
2. Disconnect key slot connector.
3. Remove the key slot scre ...
Other materials:
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
dr ...
Stall test
Inspection and Judgment
INSPECTION
1. Inspect the amount of engine oil. Replenish the engine oil if necessary.
2. Drive for about 10 minutes to warm up the vehicle so that the
CVT fluid temperature is 50 to 80°C (122 to 176°F). Inspect the
amount of CVT fluid. Replenish if necessary.
3. ...
On-vehicle repair
SUNROOF UNIT ASSEMBLY
Inspection
WIND DEFLECTOR
1. Open glass lid assembly fully.
2. Visually check for proper installation, damaged/deteriorated components, or
foreign objects within mechanism.
Correct as required for smooth operation.
3. Check for grease at the wind deflector arm ( ...