Nissan Altima 2007-2012 Service Manual: Push button ignition switch

Removal and Installation

REMOVAL

1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation".

2. Release the pawls (A) and remove the push-button ignition switch (1) from cluster lid A.

INSTALLATION

Installation is in the reverse order of removal.

    Key slot
    Removal and Installation REMOVAL 1. Remove the instrument lower panel LH. Refer to IP-12, "Removal and Installation". 2. Disconnect key slot connector. 3. Remove the key slot scre ...

    Other materials:

    Trouble diagnosis - specification value
    Description The specification (SP) value indicates the tolerance of the value that is displayed in “SPEC” of “DATA MONITOR” mode of CONSULT-III during normal operation of the Engine Control System. When the value in “SPEC” of “DATA MONITOR” mode is within the SP value, the En ...

    Oil cooler
    Removal and Installation 1. Oil pressure switch 2. Oil cooler 3. Gasket 4. Water hose (outlet) 5. Water hose (inlet) A. To water control valve housing B. To heater pipe assembly C. Hose clamp D. Clip WARNING: Be careful not to get burned, engine coolant and engine oil may be hot. CAUTI ...

    Service data and specifications (SDS)
    General Specification CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid. • Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the warranty. *1: Refe ...