Nissan Altima 2007-2012 Service Manual: Rear bumper

Removal and Installation

1. Rear bumper supports

2. Rear bumper reinforcement

3. Energy absorbing foam

4. Splash shield LH

5. Rear bumper fascia

6. Splash shield RH

REMOVAL

1. Remove the LH and RH rear combination lamps. Refer to EXL-260, "Removal and Installation".

2. Remove both the rear wheels and tires. Refer to WT-66, "Adjustment".

3. Remove the LH and RH splash shields.

4. Remove the rear bumper fascia clips and screws, then remove the rear bumper fascia.

5. Remove the rear energy absorbing foam.

6. Remove the rear bumper reinforcement.

7. Remove the rear bumper supports.

INSTALLATION

Installation is in the reverse order of removal.

    Front bumper
    Removal and Installation 1. Front bumper supports 2. Front bumper reinforcement 3. Energy absorbing foam 4. Tow cover 5. Front grille 6. Engine under cover 7. Fog lamp finisher (if equipped) ...

    Front grille
    Removal and Installation 1. Front grille 2. Bumper fascia FRONT GRILLE Removal 1. Remove the front grille clips. 2. Release the grille tabs from the front bumper fascia, then remove the ...

    Other materials:

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the dr ...

    ECM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). - ECM - Harnes ...

    B260D steering lock unit
    Description The electronic steering column lock performs the check by itself according to the steering lock status (before lock, after lock and unlock). DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Turn ig ...