Nissan Altima 2007-2012 Service Manual: Rear combination lamp

Bulb Replacement

Removal

1. Remove the rear combination lamp. Refer to EXL-260, "Removal and Installation".

2. Turn the rear turn signal lamp bulb socket counterclockwise and remove it.

3. Remove the rear turn signal lamp bulb.

Installation

Installation is in the reverse order of removal.

STOP/TAIL LAMP

Removal

1. Remove the rear combination lamp. Refer to EXL-260, "Removal and Installation".

2. Turn the stop/tail lamp bulb socket counterclockwise and remove it.

3. Remove the stop/tail lamp bulb.

Installation

Installation is in the reverse order of removal.

BACK-UP LAMP

Removal

1. Remove the rear combination lamp. Refer to EXL-260, "Removal and Installation".

2. Turn the back-up lamp bulb socket counterclockwise and remove it.

3. Remove the back-up lamp bulb.

Installation

Installation is in the reverse order of removal.

SIDE MARKER LAMP

Removal

1. Remove the rear combination lamp. Refer to EXL-260, "Removal and Installation".

2. Turn the side marker lamp bulb socket counterclockwise and remove it.

3. Remove the side marker lamp bulb.

Installation

Installation is in the reverse order of removal.

Removal and Installation

COMPONENTS

1. Rear combination lamp assembly

2. Back-up lamp bulb

3. Stop/Tail lamp bulb

4. Rear combination lamp harness

5. Side marker lamp bulb

6. Rear turn signal lamp bulb

REMOVAL

1. Remove trunk side finisher. Refer to INT-23, "Removal and Installation".

2. Remove the rear combination lamp nuts.

3. Pull the rear combination lamp assembly toward rear of the vehicle and remove.

INSTALLATION

Installation is the reverse order of removal.

    License plate lamp
    Bulb Replacement REMOVAL 1. Position trunk lid finisher aside. 2. Turn license plate lamp bulb socket counterclockwise to unlock and remove. 3. Pull license plate lamp bulb to remove from so ...

    Lighting and turn signal switch
    Removal and Installation Removal 1. Remove the spiral cable. Refer to SR-8, "Removal and Installation" 2. Disconnect the lighting and turn signal switch connector and remove the lighti ...

    Other materials:

    Power window system
    System Diagram POWER WINDOW LH ANTI-PINCH SYSTEM System Description MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH INPUT/OUTPUT SIGNAL CHART POWER WINDOW OPERATION • Power window system is operable during the retained power operation timer after turning ignition switch ON and OFF. ...

    Cylinder head
    Removal and Installation 1. Cylinder head 2. Cylinder head gasket 3. Cylinder head bolt A. Follow installation procedure REMOVAL 1. Remove the engine and transaxle assembly. Refer to EM-72, "Removal and Installation". 2. Remove the timing chain. Refer to EM-52, "Removal ...

    Power supply and ground circuit
    Diagnosis Procedure 1.INSPECTION START Start engine. Is engine running? YES >> GO TO 8. NO >> GO TO 2. 2.CHECK ECM POWER SUPPLY CIRCUIT-I 1. Turn ignition switch OFF and then ON. 2. Check the voltage between ECM harness connector and ground. Is the inspection result n ...