Nissan Altima 2007-2012 Service Manual: Rear lh side power window alone does not operate

Diagnosis Procedure

1. CHECK REAR POWER WINDOW SWITCH LH

Check rear power window switch LH.

Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check".

Is th e inspection result normal? YES >> GO TO 2

Check rear power window switch LH.

Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check".

Is th e inspection result normal? YES >> GO TO 2

2. CHECK REAR POWER WINDOW MOTOR LH

Check rear power window motor LH.

Refer to PWC-316, "REAR LH : Component Function Check".

Is th e inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

    Front passenger side power window alone does not operate
    Diagnosis Procedure 1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH Check power window and door lock/unlock switch RH. Refer to PWC-308, "FRONT POWER WINDOW SWITCH : Component Function ...

    Rear rh side power window alone does not operate
    Diagnosis Procedure 1. CHECK REAR POWER WINDOW SWITCH RH Check rear power winodw switch RH. Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check". Is the inspectio ...

    Other materials:

    Readiness for inspection/maintenance (I/M) test
    Due to legal requirements in some states and Canadian Provinces, your vehicle may be required to be in what is called the “ready condition” for an Inspection/Maintenance (I/M) test of the emission control system. The vehicle is set to the “ready condition” when it is driven through c ...

    Driving on snow or ice
    WARNING ● Wet ice (32°F, 0°C and freezing rain), very cold snow or ice can be slick and very hard to drive on. The vehicle will have much less traction or “grip” under these conditions. Try to avoid driving on wet ice until the road is salted or sanded. ● Whatever the condi ...

    BCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side). Is the inspec ...