Nissan Altima 2007-2012 Service Manual: Rear lower link & coil spring
Removal and Installation
Removal
1. Loosen the rear lower link bolt and nut from the suspension member side.
2. Support the rear lower link by placing a suitable jack under the knuckle.
3. Remove the rear lower link adjusting bolt and nut from the suspension member side using power tool.
• Do not reuse the adjusting nut, use a new adjusting nut for installation.
4. Slowly lower the jack to lower the rear lower link and coil spring.
5. Remove the upper rubber seat, coil spring, and lower rubber seat from the rear lower link.
6. Remove rear lower link bolt and nut from the suspension member side using power tool.
7. Remove the rear lower link.
Installation
Installation is in the reverse order of removal.
• Do not reuse the adjusting nut, use a new adjusting nut for installation.
• Check that the projecting part inside the upper rubber seat and the bracket flange are attached as shown.
• Check that the projection part outside the upper rubber seat is directed toward the front of the vehicle.
• Position the hollow of the lower rubber seat with the groove part of the rear lower link.
• Install the coil spring so that the side with the two paint markers is directed toward the lower side.
• Check the rear wheel alignment and adjust if necessary. Refer to RSU-18, "Rear Wheel Alignment (Unladen*)".
Front lower link
Removal and Installation Removal 1. Remove the front lower link nut and bolt from the knuckle side and the adjusting bolt and nut from the suspension member side using power tools. • Do not r ...Other materials:
Door switch
Description
Detects door open/close condition and transmits the signal to BCM.
Component Function Check
1. CHECK DOOR SWITCH INPUT SIGNAL
Check (“DOOR SW-DR” and “DOOR SW-AS”) in “DATA MONITOR” mode with
CONSULT-III. Refer to BCS-
34, "RETAINED PWR : CONSULT-III Function (BC ...
Front wiper blade
Removal and Installation
REMOVAL
1. Lift the front wiper arm and wiper blade assembly away from the
windshield.
2. Rotate the front wiper blade assembly and push the release tab
(A), then move the front wiper blade assembly down (B) the
front wiper arm.
3. Remove the front wiper blade as ...
Disassembly and assembly
DOOR MIRROR
Exploded View
1. Door mirror cover
2. Mirror housing assembly
3. Mirror glass and holder
Disassembly
1. Turn the mirror glass surface upward.
2. Apply a protective tape (A) to mirror housing. Insert a suitable
tool (B) into the concave gap between the mirror holder (1) and
...