Nissan Altima 2007-2012 Service Manual: Rear parcel shelf finisher
Exploded View
1. High mounted stop lamp
2. Rear parcel shelf finisher
3. Seatback release cover
4. Child anchor cover
5. Seatback latch cover
Removal and Installation
REMOVAL
1. Remove rear seat cushion. Refer to SE-25, "Removal and Installation" 2. Remove rear lower finisher RH/LH. Refer to INT-15, "Removal and Installation".
3. Remove rear pillar finisher RH/LH. Refer to INT-15, "Removal and Installation".
4. Remove upper pillar finisher RH/LH. Refer to INT-15, "Removal and Installation".
5. Remove the clips, then remove rear seatback latch cover.
6. Remove high mounted stop lamp. Refer to INT-15, "Removal and Installation".
7. Remove the clips, then remove rear parcel shelf finisher.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Make sure that clips are fully aligned with panel holes on body when installing, then press them in completely.
Body side trim
Exploded View
1. Front pillar finisher
2. Front body side welt
3. Front kicking plate
4. Front sill cover
5. Rear lower finisher
6. Upper pillar finisher
7. Rear pillar finisher
Removal ...
Floor trim
Exploded View
1. Spacer (LH)
2. Floor carpet
3. Spacer (RH)
4. Floor mat hook
Removal and Installation
REMOVAL
1. Remove the diagnosis sensor unit. Refer to SR-17, "Removal and
Inst ...
Other materials:
Seat belt extenders
If, because of body size or driving position, it is
not possible to properly fit the lap/shoulder belt
and fasten it, an extender that is compatible with
the installed seat belts is available that can be
purchased. The extender adds approximately 8 in
(200 mm) of length and may be used for eith ...
Tweeter (sedan)
Description
The audio unit sends audio signals to the tweeters using the door speaker
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect audio unit connector M43 (A) and suspect tweeter
connector (B).
2. Check continuity between audio unit harness connector M43 (A)
and suspect t ...
U124C CD changer
Description
Refer to AV-240, "System Description".
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK CD CHANGER POWER SUPPLY AND GROUND CIRCUIT
Check CD changer power supply and ground circuit. Refer to AV-318, "CD
CHANGER : Diagnosis Procedure".
Do power ...