Nissan Altima 2007-2012 Service Manual: Rear parcel shelf finisher

Exploded View

1. Seatback release escutcheon

2. Seatback release cover

3. Child anchor cover

4. Seatback latch cover

5. Rear parcel shelf finisher

6. High mounted stop lamp (if equipped)

A. Clip C205

Removal and Installation

REMOVAL

1. Release seatback latch RH/LH, then fold both rear seatbacks to forward most position.

2. Remove the clips, then remove rear seatback latch cover.

3. Lift seatback release cover, release the tabs and remove seatback release escutcheon from rear parcel shelf finisher.

4. Remove high mounted stop lamp (if equipped). Refer to INT-36, "Removal and Installation".

5. Remove rear pillar finisher RH/LH. Refer to INT-36, "Removal and Installation".

6. Thread the rear seat belt RH/LH/Center through vertical opening and release from rear parcel shelf finisher.

7. Remove the clips, then remove rear parcel shelf finisher.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Make sure that clips are fully aligned with panel holes on body when installing, then press them in completely.

    Body side trim
    Exploded View 1. Front pillar finisher 2. Dash side lower finisher 3. Front kicking plate 4. Front sill cover 5. Center pillar lower finisher 6. Rear sill cover 7. Rear kicking plate 8. Rear ...

    Floor trim
    Exploded View 1. Spacer (RH) 2. Spacer (LH) 3. Floor mat hook 4. Floor carpet 5. Harness clamp Removal and Installation REMOVAL 1. Remove front seat (RH/LH) and rear seat cushion. Refer ...

    Other materials:

    Insufficient cooling
    Component Function Check SYMPTOM: Insufficient cooling INSPECTION FLOW 1. CONFIRM SYMPTOM BY PERFORMING OPERATION CHECK - TEMPERATURE DECREASE 1. Press the A/C switch. 2. Turn temperature control dial counterclockwise to maximum cold. 3. Check for cold air at discharge air outlets. Can ...

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). >> GO TO 2 2.CHECK DTC WITH BCM AND IPDM E/R 1. Check “Self Diagn ...

    B2609 steering status
    Description There are 2 switches in the electronic steering column lock (steering lock/unlock switch 1 and 2). BCM compares those two switches conditions to judge the present steering status. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2609 is displayed with DTC U1000, first perform the ...