Nissan Altima (L32) 2007-2012 Service Manual: Rear regulator
Exploded View
1. Rear door
2. Door glass run
3. Door glass
4. Inside seal
5. Partition sash
6. Rear window seal
7. Door rear, glass
8. Regulator assembly
9. Window motor
10. Water shield
Removal and Installation
REMOVAL
1. Remove the rear door finisher. Refer to INT-34, "Removal and Installation".
2. Remove the plastic vapor barrier, being careful not to tear/damage it.
3. Temporarily reconnect the power window switch to the door harness.
4. Operate the power window switch to raise/lower the door window until the glass mounting bolts (A) can be seen.
5. Remove the door glass bolts (A).
6. Raise up the door glass and hold with a suction lifter (A).
7. Disconnect the window motor connector.
8. Remove the window regulator bolts (A) and remove the window regulator from the rear door panel.
INSTALLATION
Installation is in the reverse order of removal.
• After installation, inspect and adjust as necessary.
Inspection
Inspection after Removal
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
• Gear wear
• Regulator deformation
• Grease condition for each sliding part
Apply multi-purpose grease at points (A) shown.
FINAL INSPECTION
• Make sure the glass is securely fit into the glass run groove.
• Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)], and make sure the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator mounting bolts, guide rail mounting bolts, and glass and carrier plate mounting bolts to correct the glass position.
Rear door glass
Exploded View 1. Rear door 2. Door glass run 3. Door glass 4. Inside seal 5. Partition sash 6. Rear window seal 7. Door rear, glass 8. Regulator assembly 9. Window motor 10. Water shield ...Side window glass
Components 1. Windshield glass 2. Spacer 3. Seal 4. Body side outer 5. Primer 6. Adhesive 7. Encapsulation E. 7(0.28) F. 12 (0.47) G. 15 (0.59) Removal and Installation REMOVAL 1. Remov ...Other materials:
Sound signal circuit (sedan)
SATELLITE RADIO TUNER
Description
Left and right channel audio signals are supplied from the satellite radio
tuner to the audio unit through the
sound signal circuits.
Diagnosis Procedure
LEFT CHANNEL
1.CHECK HARNESS
1. Turn ignition switch OFF.
2. Disconnect satellite radio tune ...
ODO/TRIP meter
System Diagram
System Description
The vehicle speed signal and the memory signals from the meter memory circuit
are processed by the combination
meter and the mileage is displayed.
HOW TO CHANGE THE DISPLAY FOR ODO/TRIP METER
Refer to Owner's Manual for odo/trip meter operating instruction ...
Making a call
To make a call from a phone connected to the
vehicle’s Bluetooth® Hands-Free Phone System:
1. Press the button on the
steering
wheel.
2. The system will prompt you for a command.
Say “Call”.
3. Select one of the available voice commands
to continue:
● “(A Name)” — Spea ...