Nissan Altima 2007-2012 Service Manual: Rear stabilizer
Removal and Installation
Removal
1. Disconnect the stabilizer bar from connecting rod, using power tools.
2. Remove the stabilizer bar clamps and bushings using power tools.
3. Remove the stabilizer bar.
Installation
Installation is in the reverse order of removal.
Radius rod
Removal and Installation
Removal
1. Remove the rear suspension assembly. Refer to RSU-12, "Removal and
Installation".
2. Remove the radius rod using power tools.
Installation
Insta ...
Suspension ARM
Removal and Installation
Removal
1. Remove the rear suspension assembly. Refer to RSU-12, "Removal and
Installation".
2. Remove the connecting rod bracket from the suspension arm usin ...
Other materials:
Common ITEM
Diagnosis Description
BCM CONSULT-III FUNCTION
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system
s ...
Windshield glass
Components
1. Windshield glass
2. Spacer
3. Mirror base
4. Adhesive
5. Roof panel
6. Front pillar outer panel
7. Cowl top center
8. Primer
E. 7(0.28)
F. 12 (0.47)
G. 7.5 (0.30)
H. 16 (0.63)
I. 25 (0.98)
J. 12.5 (0.49)
Removal and Installation
REMOVAL
1. Partially remove the headl ...
B210D starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210D is display ...