Nissan Altima (L32) 2007-2012 Service Manual ≻ Audio, visual & navigation system bose audio with navigation ≻ Component diagnosis ≻ Power supply and ground circuit (sedan) ≻ Rear view camera

Nissan Altima (L32) 2007-2012 Service Manual: Rear view camera

Diagnosis Procedure

1.CHECK POWER SUPPLY CIRCUIT (REAR VIEW CAMERA SIDE)

Check voltage between rear view camera harness connector and ground.

Is inspection result normal? YES >> GO TO 4

NO >> GO TO 2

2.CHECK POWER SUPPLY CIRCUIT (CONTINUITY)

1. Turn ignition switch OFF.

2. Disconnect rear view camera and rear view camera control unit connectors.

3. Check continuity between rear view camera harness connector B35 (A) terminal 1 and rear view camera control unit harness connector B31 (B) terminal 8.

4. Check continuity between rear view camera harness connector B35 (A) terminal 1 and ground.

Is inspection result normal? YES >> GO TO 3

3.CHECK POWER SUPPLY CIRCUIT (CAMERA CONTROL UNIT SIDE)

1. Connect rear view camera control unit harness connector.

2. Turn ignition switch ON.

3. Check voltage between rear view camera control unit harness connector and ground.

Is voltage approximately 6V? YES >> Inspection End.

NO >> Replace rear view camera control unit. Refer to AV-458, "Removal and Installation - Sedan".

4.CHECK GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect rear view camera harness connector.

3. Check continuity between rear view camera harness connector B35 terminal 2 and ground.

Is inspection result normal? YES >> Inspection End.

NO >> Repair harness or connector.

Rear view camera control unit

Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the rear view camera control unit are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate ca ...

Bose speaker AMP

Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the BOSE speaker amp. are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of m ...

Other materials:

P0745 line pressure solenoid valve
Description The pressure control solenoid valve A (line pressure solenoid valve) regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE NOTE: If “DTC CONFIRMATION PROCE ...

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of ...

Noise
Component Function Check SYMPTOM: Noise INSPECTION FLOW *1 HAC-5, "Operational Check" *2 EM-16, "Checking Drive Belts" (QR25DE) or EM-121, "Checking Drive Belts" (VQ35DE) *3 HAC-87, "Performance Chart" *4 HA-45, "Removal and Installation for E ...