Nissan Altima (L32) 2007-2012 Service Manual: Rear view camera
Removal and Installation
REMOVAL
1. Remove the license plate finisher. Refer to EXT-23, "Removal and Installation" (coupe) and EXT-46, "Removal and Installation" (sedan).
2. Remove trunk lid finisher. Refer to INT-22, "Exploded View".
3. Remove the rear view camera by performing the following: • For coupe models, release the clip (A), then pull out the rear view camera connector, disconnect the rear view camera connector, press the rear view camera tab (B) and remove the rear view camera (1).
• For sedan models, disconnect the rear view camera connector (B), press the rear view camera tab (A) and remove the rear view camera (1).
INSTALLATION
Installation is in the reverse order of removal.
Adjustment
REAR VIEW MONITOR
For adjustment on the rear view camera, refer to AV-238, "REAR VIEW MONITOR GUIDING LINE ADJUSTMENT : Special Repair Requirement".
Microphone
Removal and Installation REMOVAL 1. Remove the room/map lamp assembly. Refer to INL-121, "Removal and Installation". 2. Detach the microphone connector (A). 3. Remove the map lamp ...Camera control unit
Removal and Installation - Coupe REMOVAL 1. Disconnect the negative battery terminal. 2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal and Installation&quo ...Other materials:
Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs.Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any
customer's ...
Fuel pressure
Inspection
FUEL PRESSURE RELEASE
1. Turn ignition switch ON.
2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III.
3. Start engine.
4. After engine stalls, crank it 2 or 3 times to release all fuel pressure.
5. Turn ignition switch OFF.
1. Remove fuel ...
Intelligent Around View Monitor
system operation
With the ignition switch in the ON position,
move the shift lever to the R (Reverse) position
or press the CAMERA button to operate
the Intelligent Around View Monitor.
The screen displayed on the Intelligent
Around View Monitor will automatically return
to the previous screen 3 minutes after
the C ...