Nissan Altima 2007-2012 Service Manual: Rear view camera control unit
Diagnosis Procedure
1.CHECK FUSE
Check that the following fuses of the rear view camera control unit are not blown.
Are the fuses OK? YES >> GO TO 2
NO >> Be sure to eliminate cause of malfunction before installing new fuse.
2.CHECK POWER SUPPLY CIRCUIT
Check voltage between rear view camera control unit harness connector and ground.
Are the voltage readings as specified? YES >> GO TO 3
NO >> Check harness between rear view camera control unit and fuse.
3.CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect rear view camera control unit connector.
3. Check continuity between rear view camera control unit harness connector B31 terminal 3 and ground.
Does continuity exist? YES >> Inspection End.
NO >> Repair harness or connector.
AV control unit
Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the AV control unit are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfuncti ...Rear view camera
Diagnosis Procedure 1.CHECK POWER SUPPLY CIRCUIT (REAR VIEW CAMERA SIDE) Check voltage between rear view camera harness connector and ground. Is voltage reading approximately 6 volts? YES &g ...Other materials:
Navigation system (coupe)
System Diagram
System Description
NOTE:
Refer to NAVI System Owner's Manual for system operation.
The navigation system periodically calculates the vehicle's current
position according to the following three signals: Travel distance of
the vehicle as determined by the vehicle speed sensor, ...
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the
dr ...
Power consumption control system
System Diagram
System Description
OUTLINE
• IPDM E/R incorporates a power consumption control function that reduces the
power consumption according
to the vehicle status.
• IPDM E/R changes its status (control mode) with the sleep wake up signal
received from BCM via CAN communicat ...