Nissan Altima (L32) 2007-2012 Service Manual: Rear view monitor system (sedan)
System Diagram
System Description
When the selector is in the R position, the display will show a view to the rear of the vehicle. Lines which indicate the vehicle clearance and distances are also displayed.
AV COMMUNICATION LINE
The rear view camera control unit is connected to the AV control unit using an AV communication line. This line is used to transmit and receive data.
Component Parts Location
1. Tweeter LH M51
2. Steering wheel audio control switches
3. CD changer M42
4. Tweeter RH M52
5. AV control unit M46, M47, M48, M81, M90, M91
6. Center speaker M151
7. Combination meter M24
8. Front door speaker
LH D3
RH D103
9. Rear subwoofer RH B124
10. Rear subwoofer LH B120
11. Rear door speaker
LH D202
RH D302
12. Antenna amp M502 (view with rear pillar finisher RH removed)
13. BOSE speaker amp. B121, B122
14. Microphone R7
15. Rear view camera control unit B31 (view with trunk side finisher LH removed)
16. Rear view camera B35
Component Description
Rear view monitor system (coupe)
System Diagram System Description When the selector is in the R position, the display shows a view to the rear of the vehicle. Lines which indicate the vehicle clearance and distances are also ...Audio system (coupe)
System Diagram System Description AUDIO SYSTEM The audio system consists of the following components • AV control unit (audio unit) • BOSE speaker amp. • Window antenna • Steering w ...Other materials:
B2099 ignition relay off stuck
Description
• IPDM E/R operates the ignition relay when it receives an ignition switch ON
signal from BCM via CAN communication.
• Turn the ignition relay OFF by pressing the push-button ignition switch once
when the vehicle speed is 4 km/
h (2.5 MPH) or less.
• Turn the ignition ...
Installing top tether strap
First, secure the child restraint with the LATCH
lower anchors (rear outboard seat positions only)
or the seat belt, as applicable.
1. Flip up the anchor cover 1 from the anchor
point which is located directly behind the
child seat.
2. Position the top tether strap over the top of
the hea ...
Main line between dlc and abs circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector side
and harness side).
- Harness co ...