Nissan Altima Owners Manual: Receiving a call
When a call is placed to the connected phone, the display will change to phone mode.
To accept the incoming call, either:
● Press the 
button on the
steering
wheel, or
● Touch the 
icon on the screen.
To reject the incoming call, either:
● Press the 
button on the steering
wheel, or
● Touch the red phone icon on the screen.
Making a call
To make a call, follow the procedure below:
1. Press the button on
the control panel.
The “Phone” screen will appear on the display.
2. Select one of the following options to make a
...
During a call
While a call is active, the following options are
available on the screen:
● “Handset”
Select this option to switch control of the
phone call over to the handset.
● “Mute Mic. ...
Other materials:
Anti-pinch system does not operate
normally (passenger side)
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to PWC-190, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special
Repair Requirement".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the ma ...
Diagnosis system (audio unit)
Diagnosis Description
Self-diagnosis mode can check the following items.
• Audio unit hardware/software versions
• Continuity of each speaker channel
• Continuity of each audio unit switch
OPERATION PROCEDURE
1. Turn ignition switch to the ACC position.
2. Turn the audio unit off.
...
B2617 starter relay circuit
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2617 is display ...
