Nissan Altima (L32) 2007-2012 Service Manual: Refrigerant pressure sensor
Removal and Installation for Refrigerant Pressure
Sensor
REMOVAL
1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service
Procedure".
2. Remove the front grille. Refer to EXT-17, "Removal and Installation".
3. Disconnect the refrigerant pressure sensor connector and
remove the refrigerant pressure sensor (1) from the liquid tank
on the condenser.
CAUTION:
Do not damage the condenser fins.
INSTALLATION
Installation is in the reverse order of removal.
Refer to HA-31, "Component".
CAUTION:
Replace the O-ring of the refrigerant pressure sensor with a new one, then apply
compressor oil to it
when installing it.
Removal and Installation
REMOVAL
1. From under the vehicle, disconnect the ambient sensor connector
(2).
2. Release the ambient sensor clip and remove the ambient sensor
(1).
INSTALLATION
I ...
Removal and Installation for Expansion Valve
REMOVAL
1. Discharge the refrigerant. Refer to HA-32, "HFC-134a (R-134a) Service
Procedure".
2. Remove the strut tower bar. Refer to FSU-1 ...
Other materials: Phone display screen
The Phone screen can be displayed by
pressing thebutton on the control
panel.
The following options are displayed:
Quick Dial
Displays the Quick Dial screen. For additional
information, see "Quick dial".
Phonebook
Displays the Phonebook screen. For additional
information, see "Making a call ...
Sonar limitations
WARNING
Listed below are the system limitations
for the sonar system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death.
The system is deactivated at speeds
above 6 mph (10 km/h). It is reactivated
at lower speeds.
Inclement weath ...
Regulatory information
FCC Regulatory information
CAUTION: To maintain compliance with
FCC’s RF exposure guidelines, use only
the supplied antenna. Unauthorized antenna,
modification, or attachments
could damage the transmitter and may
violate FCC regulations.
Operation is subject to the following two
condition ...